FrameStand Photo Gallery

(3) connectors and a small mating harness was supplied by the customer. The connectors were arranged and mounted on a framestand board in a layout that accomodated the size and reach of the harness. (shown mated to connectors)	1 of 2. A custom "pogo pin test block" was created to accomodate a short ribbon cable assembly which needed to be easy to mount and dismount from the test block. The test block itself was mounted to a framestand board to make that easy to setup and remove from the cable tester.	2 of 2. This photo shows the underside of the framestand board of the "pogo pin test block" shown to the left.

Here is a very unique 18 pos. connector with bare mating pins displayed. This connector was mounted to a standard G-10 framestand board (ACLP-G1) and wired down to a standard 20 position dual row female connector. That connector can in turn be mated to our standard AHED-20 adapter. (not shown)	A rectangular ZIF connector is mounted to a clear framestand board. This 100 position connector is wired through ribbon cables to two 64 pos. dual row female connectors which are mated to standard AHED-64 header adapters.	Another interesting project! Common connectors need to mate to a flex cable. (bends in one plane.) The connectors needed to be positioned precisely on the framestand board to allow easy mating to the flex cable under test. As with the others the connectors are attached via cable to the standard adapters below.

Cirris Systems- Our Products- Adapters - Special Adapters - Framestand Photo Gallery
Toll-free 1-800-441-9910